MYMESH-HBWD is compatible with Mymesh commissioning tools.
To be installed by a competent person with reference to BS 7671 or equivalent local standards. If in doubt consult a qualified electrician.
- Plan where the MYMESH-HBWD is to be located (see diagram 1). Switch off supply and check for hidden cables and pipes.
- The MYMESH-HBWD should be connected as shown in diagram 2:L – Live in. N – Neutral in.
- Knockout or drill the appropriate holes on the mounting plate for attaching the plate to the ceiling or back box (if applicable). Feed cables through
the appropriate (side or rear) entry hole. Screw the back mounting plate to the ceiling or backbox via the mounting holes. Wire the cables into the sensor head block terminal. Push the sensor head onto the mounting plate and align the side clips with the slots on the sensor heads.