Mymesh COPDBK - Chess



Article number:

About the product

This MYMESH-COPD-BK Lighting Control has an IP66 rated weatherproof enclosure and can be surface mounted onto an external wall. Configurable for any room occupancy style, via the Mymesh App.

Easy Installation

MYMESH-COPD-BK is compatible with Mymesh commissioning tools.

To be installed by a competent person with reference to BS 7671 or equivalent local standards. If in doubt consult a qualified electrician.

  • Plan where the MYMESH-COPD-BK is to be located (see diagram 1). Switch off supply and check for hidden cables and pipes.
  • The detector should be sited so that it is not shaded from daylight.
  • Make sure the power is isolated from the circuit.
  • Remove the front cover by removing the two screws on the front face of the product.
  • Remove the terminal cover (see diagram 3).
  • The detector should be mounted between 1 and 2.2 metres high, via any of the four pre-drilled mounting holes only and must be mounted with the cable entering from below.
  • Thread mains cable carefully through the required membrane entry point.
  • The MYMESH-COPD should be connected as shown in diagram 2:L – Live in. N – Neutral in.
  • IMPORTANT – Replace the terminal cover.
  • Replace the front cover ensuring the two screws are secured.

Technical Summary

Network features

  • Wireless, stand-alone network that is self-organizing and self-healing
  • 2.4GHz communication for reliable data transfer
  • Secure by design
  • Ultra-scalable to > 10.000 fixtures in one network
  • Low operational cost


  • On-the-fly (re) commissioning with a Mymesh BLE Gateway and Mymesh commissioning app for iPad
  • Connect to third-party back-office / Light Management system (LMS) via a Mymesh Ethernet Gateway
Categories: ,


Reviews (0)


There are no reviews yet.

Be the first to review “Mymesh COPDBK”

Your email address will not be published.